Do not let children use or play with the appliance. Only use the appliance for its intended domestic use. Note: Kenwood will not accept any liability if the appliance is For non-rewireable plugs the fuse cover MUST be subject to improper use, or failure to comply with these refitted when replacing the fuse.
- see 360° powerbase “descaling”. If descaling does not solve the cord wrap problem contact Kenwood customer care. preparing the cartridge boil-dry protection If you switch on with too little water, your kettle will cut 1 Remove wrapper and immerse the cartridge in cold out automatically.
(unless by Kenwood); the flat element may be damaged. it is not second-hand; Please note: failure to descale your kettle may invalidate it has not been used commercially;...
Page 7
kettle trouble shooting guide problem possible cause solution Kettle does not switch on (no No power Check power to kettle indicator light) Hopper not fitted The kettle will not operate without the hopper fitted. Fuse blown Check the fuse/circuit breaker for your installation and replace the fuse if necessary.
Page 8
cartridge trouble shooting guide question answer The cartridge is damp and there is moisture in the bag. Is this normal? Why do you need to soak the cartridges? The cartridge contains a filtration medium that needs to be kept moist to do its job effectively. The plastic wrapper helps to retain the moisture during transit, but to ensure the cartridge works effectively it needs to be soaked for 10 minutes before use.