Kenwood SJ400 series User Manual

G
safety This kettle is for domestic use only.
G
Failure to observe these cautions
G
Always use the filter and never
may result in damage to the kettle.
overfill - boiling water may splash
before plugging in
out.
G
Make sure your electricity supply is
G
Avoid contact with steam coming
the same as the one shown on the
out of the spout area when
underside of your kettle.
pouring and out of the lid when
important - UK only
refilling.
G
The wires in the cord are coloured
G
Beware: the metal body of the
as follows:
kettle will get hot during operation.
Green and Yellow = Earth, Blue =
G
Keep small children away from the
Neutral, Brown = Live.
kettle and never let the cord hang
G
The appliance must be protected
down over the worktop edge - a
by a 13A approved (BS1362) fuse.
child could grab it and pull the
G
WARNING: THIS APPLIANCE
kettle down.
MUST BE EARTHED.
G
If you do not need so much cord,
shorten it by wrapping any excess
Note:
cord around the bracket on the
G
For non-rewireable plugs the fuse
underside of the powerbase .
cover MUST be refitted when
G
Always unplug your kettle
replacing the fuse. If the fuse cover
when not in use.
is lost then the plug must not be
G
Never put the kettle, powerbase,
used until a replacement can be
cord or plug in liquid.
obtained. The correct fuse cover is
G
Do not use if there is any damage
identified by colour and a
to the kettle, powerbase, cord or
replacement may be obtained from
plug. Get it checked or repaired:
your Kenwood Authorised Repairer
see 'service'.
(see Service).
G
This kettle is not intended for use
G
If a non-rewireable plug is cut off it
by young children or infirm persons
must be DESTROYED
without supervision.
IMMEDIATELY. An electric shock
G
Young children should be
hazard may arise if an unwanted
supervised to ensure they do not
non-rewireable pug is inadvertently
play with the appliance.
inserted into a 13A socket outlet.
G
Caution: Do not operate the
G
This kettle complies with European
kettle on an inclined surface.
Economic Community Directive
G
Only use the powerbase supplied
89/336/EEC.
and keep it clean and dry.
G
before using for the first
Make sure the lid is secure before
time
switching the kettle on.
G G
Warning: Do not remove the lid Remove all packaging and any
while the water is boiling. labels.
G
G Fill to 'MAX', boil, then pour the
Make sure the kettle is switched
off before lifting or pouring. water away. Repeat 2 to 3 times.
G
Remove the kettle from the base
before filling or pouring.
G
Never put the kettle near or on
cooker hot plates or gas burners.
G
This kettle is for boiling water only.
know your Kenwood boil-dry protection
G
If you switch on with too little
stainless steel jug kettle
water, your kettle will cut out
automatically. Switch off and let it
spout
cool down before re-filling.
lid
When it has cooled down, the
water gauge
switch will reset itself.
on/off switch with neon
360˚ powerbase
care and cleaning
cord storage
scale filter
Before cleaning, unplug your kettle
and let it cool down.
to use your stainless
the outside and powerbase
steel jug kettle
G
Wipe with a damp cloth, then dry.
Do not use abrasives - they will
1 Fill it through the spout or lid. The
scratch the metal and plastic
water level must be between 'Max'
surfaces.
and 200ml (1 cup).
the inside
G
Always use the filter and never
G
Wipe with bicarbonate of soda on
overfill - boiling water may splash
a damp cloth. Rinse thoroughly.
out.
G
Even though your kettle comes
G
Be economical: do not boil more
with a scale filter, you still need to
water than you need.
clean the inside (and the filter)
G
To improve the quality of your
regularly.
drinks always use fresh water.
G
Empty the kettle after each use.
the scale filter
2 Check the lid is closed.
1 Open the lid.
3 Plug in and switch on. The neon
2 Remove the scale filter by
will come on.
holding the tab and then lifting the
4 Your kettle will boil and switch off
filter out.
automatically. To re-boil, wait a
3 either rinse under the tap or use
few seconds - the on/off switch
a soft brush
needs time to reset.
or when descaling your kettle,
G
If you experience problems
drop the filter in too. Rinse
with your kettle switching thoroughly.
on and off during use or
4 To re-fit the filter, hold the tab
switching off before boiling,
Then slide the filter down into the
check that the flat element
bracket until secure
is free from scale - see
"descaling". If descaling
does not solve the problem
contact Kenwood customer
care.
G
Your kettle is fitted with a scale
filter to hold back limescale
particles.
G
If you find drops of water under
your kettle, don't worry - it is just
condensation.
.
.