Set DVB channel manually [Manual Tuning]
Normally use [Auto Setup] or [Update Channel List] to retune DVB channels.
If tuning has not been done completely or for adjusting the direction of the aerial or dish, use this function.
●
All channels found will be added to the Channel List.
DVB-S:
1
Set the satellite
DVB-S Manual Tuning
Signal Quality
Signal Strength
Satellite
Transponder Frequency
Symbol Rate
Polarisation
Modulation
Service ID
Start scan
2
Set [Transponder Frequency], [Symbol Rate],
[Polarisation], [Modulation] and [Service ID]
DVB-C:
1
Enter the frequency
DVB-C Manual Tuning
Frequency
Symbol Rate
Service ID
Start scan
Signal Quality
Signal Strength
No.
Channel Name
●
Normally set [Symbol Rate] and [Service ID] to [Auto].
DVB-T:
1
Adjust frequency for each channel
DVB-T Manual Tuning
Frequency
Signal Quality
Signal Strength
No.
Channel Name
●
Set where the level of [Signal Quality] becomes the maximum.
Set Analogue channel manually [Manual Tuning]
[Fine Tuning]:
Use to make small adjustments to the tuning of an individual programme (affected by weather conditions, etc.).
[Manual Tuning]:
Set Analogue channel manually after Auto Setup.
●
Set [Sound System] and [Colour System], and then perform this function. Normally set [Colour System] to [Auto].
●
If a VCR is connected only with the RF cable, select channel position [0].
Analogue Manual Tuning
1 BBC1
Fine Tuning
Manual Tuning
2
Sound System
Colour System
Store
1
Select the channel position
3
Search
54
100%
100%
Astra 19.2° E
10847 MHz
●
Please consult the received satellite broadcasting companies for the
Auto
Horizontal
setting.
Auto
Auto
select
change
4
74,00 MHz
Auto
Auto
100%
100%
Type
New
[CH21]
474,00 MHz
100
%
100%
Type
New
SC1: PAL B, G, H / SECAM B, G
CH33
SC2: PAL I
78
1
41
SC1
SC3: PAL D, K / SECAM D, K
Auto
F: SECAM L, L'
select
set
3
Select [Start scan]
select
access
2
Select [Start scan]
select
access
select channel
adjust frequency
2
Select the channel
4
Select [Store]
select
store
2
Search