LG LE1004 Use Manual page 16

Chapter 1 Before use
⑦
⑧
⑨
⑩
⑪
B. Hard disk replacement
First turn of the power of the device and then unplug the power
①
②
③
④
⑤
⑥
⑦
⑧ Reference
1-10
Connect the SATA cable to the hard disk
<Connecting power cable>
Connect the SATA cable to the SATA port of the main
.
board
Close the cover of the main unit
.
Tighten the screws
After installing the hard disk, you must format the
hard disk from the setting menu
- The first SATA cable port on the main board must be connected at all times. If a
hard disk is not connected, this device may not operate normally
Loosen the screw on the left, right and rear side of the product
Separate the cover of the main unit
After removing all of power/S-ATA cable connected to hard disk, please separate
hard disk bracket from the body
Loosen the screws on the left and right side of the bracket holding the hard disk
Separate the hard disk from the bracket holding the hard disk
In the reverse order of removing the hard disk, assemble the new hard disk
After replacing the hard disk, turn on the power of the device
-
Each SATA cable must be connected to the connecting port precisely
-
Do not vertically put the hard disk in upright position or put other objects on top
.
of the hard disk
-
When connecting/disconnecting the hard disk, do not use a motored tool
-
Refer to the following when adding/replacing the hard disk
.
<Connecting SATA cable>
.
.
.
.
.
.
.
.
.
.
.
.
.
.