Kenwood SJ980 series User Manual

G
safety Failure to observe these cautions
may result in damage to the kettle.
G
Always use the filter and never
before plugging in
overfill - boiling water may splash
G
Make sure your electricity supply is
out.
the same as the one shown on the
G
Avoid contact with steam coming
underside of your kettle.
out of the spout area when
Important – UK only
pouring and out of the lid when
G
The wires in the cord are coloured
refilling.
as follows:
G
Beware: the metal body of the
Green and Yellow = Earth,
kettle will get hot during operation.
Blue = Neutral,
G
Keep small children away from the
Brown = Live.
kettle and never let the cord hang
G
The appliance must be protected
down over the worktop edge - a
by a 13A approved (BS1362) fuse.
child could grab it and pull the
G
WARNING: THIS APPLIANCE
kettle down.
MUST BE EARTHED.
G
If you do not need so much cord,
shorten it by winding any excess
Note:
cord inside the powerbase .
G
For non-rewireable plugs the fuse
G
Always unplug your kettle
cover MUST be refitted when
when not in use.
replacing the fuse. If the fuse cover
G
Never put the kettle, powerbase,
is lost then the plug must not be
cord or plug in liquid.
used until a replacement can be
G
Do not use if there is any damage
obtained. The correct fuse cover is
to the kettle, powerbase, cord or
identified by colour and a
plug. Get it checked or repaired:
replacement may be obtained from
see 'service'.
your Kenwood Authorised Repairer
G
This kettle is not intended for use
(see Service).
by young children or infirm persons
G
If a non-rewireable plug is cut off it
without supervision.
must be DESTROYED
G
Young children should be
IMMEDIATELY. An electric shock
supervised to ensure they do not
hazard may arise if an unwanted
play with the appliance.
non-rewireable pug is inadvertently
G
Caution: Do not operate the
inserted into a 13A socket outlet.
kettle on an inclined surface.
G
This kettle complies with European
G
Only use the powerbase supplied
Economic Community Directive
and keep it clean and dry.
89/336/EEC.
G
Make sure the lid is secure before
before using for the first
switching the kettle on.
G time
Warning: Do not remove the lid
G
while the water is boiling. Remove all packaging and any
G
Make sure the kettle is switched labels.
G
Adjust the length of the cord - pull
off before lifting or pouring.
G
Remove the kettle from the base the cord out of the base to
before filling or pouring. lengthen. To shorten the cord turn
G the handle on the underside of the
Never put the kettle near or on
powerbase clockwise.
cooker hot plates or gas burners.
G G
This kettle is for boiling water only. Fill to 'MAX', boil, then pour the
G
This kettle is for domestic use only. water away. Repeat 2 to 3 times.
know your Kenwood boil-dry protection
G
If you switch on with too little
jug kettle
water, your kettle will cut out
automatically. Switch off and let it
lid
cool down before re-filling.
scale filter
When it has cooled down, the
water level gauges
switch will reset itself.
on/off switch with neon
360˚ powerbase
care and cleaning
cord winder handle
Before cleaning, unplug your kettle
to use your jug kettle
and let it cool down.
1 Fill the kettle through the lid. The the outside and powerbase
G
Wipe with a damp cloth, then dry.
water level must be between 'Max'
Do not use abrasives - they will
and 200ml (1 cup).
G
Always use the filter and never scratch the metal and plastic
surfaces.
overfill - boiling water may splash
out.
the inside
G
Be economical: do not boil more
G
Wipe with bicarbonate of soda on
water than you need.
a damp cloth. Rinse thoroughly.
G
To improve the quality of your
G
Even though your kettle comes
drinks always use fresh water.
with a scale filter, you still need to
G
Empty the kettle after each use.
clean the inside (and the filter)
2 Check the lid is closed.
regularly.
3 Plug in and switch on. The neon
the scale filter
will come on.
1 Remove the lid.
4 Your kettle will boil and switch off
2 Lift out the scale filter
automatically. To re-boil, wait a
3 either rinse under the tap or use
few seconds - the on/off switch
a soft brush
needs time to reset.
or when descaling your kettle,
G
If you experience problems
drop the filter in too. Rinse
with your kettle switching
thoroughly.
on and off during use or
4 Replace the filter by locating the
switching off before boiling,
front of the filter into the spout area
check that the flat element
and then clip into place
is free from scale - see
"descaling". If descaling
does not solve the problem
contact Kenwood customer
care.
G
Your kettle is fitted with a scale
filter to hold back limescale
particles.
G
If you find drops of water under
your kettle, don't worry - it is just
condensation.
.
.