Sanyo DMP-P7 Instruction Manual page 6

Install/Replace Backup Battery
The clock radio uses a backup battery system to provide continuous alarm operation and clock settings in the
event of a power failure. If the Backup Battery has been installed and a power failure occurs or the AC cord is
accidentally disconnected, the display will not remain lit, but the current time and alarm time settings will be
temporarily maintained. Otherwise, you must reset the time and alarm settings.
1. Please make sure the AC cord is connected. Otherwise all settings may be lost during battery replacement.
2. Open the battery compartment cover located on the bottom of the unit.
3. Insert 2 "AA" batteries, checking that the polarity (+ and - ends of the batteries) matches the drawing inside
the battery compartment. We recommend the use of alkaline batteries for longer life. Different types of
batteries or new and used batteries are not to be mixed.
4. Close the compartment cover.
Batteries information:
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.
Maintenance
Place the unit on a level surface away from sources of direct sunlight or excessive heat.
Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other
protective material should be placed between it and the furniture.
Clean your unit with a soft cloth moistened only with mild soap and and water. Stronger cleaning agents,
such as Benzine, thinner or similar materials can damage the surface of the unit.
Before Operation
Turning the power on and off
- Press the / STANDBY button to turn on the power, the display lights.
- To turn the power off, press the
- When the mains lead is connected to the AC outlet, the unit will respond to commands from the
remote controller.
CONNECTIONS
Note:
- Do not connect the main lead to an AC outlet until all connection have been made.
- The system is not completely disconnected from the mains when the
(standby mode).
Getting Started
/ STANDBY button again.
4
/ STANDBY button is set to the position