Sanyo DMP-P8 Instruction Manual page 11

Operating Instructions
ІІ) SETTING 1 or 2 ALARMS
You can only set your Alarm mode at Standby mode.
A. Set Alarm 1
1) While the unit is at STANDBY
mode, press and hold ALARM 1
button on the top panel for 2 sec.
and the hour digit will begin
flashing. Press TUNE/SKIP button
to set the hour. Press "ALARM 1"
button to confirm.
2) Minute digit will begin flashing,
press "TUNE/SKIP" button to set
the minute. Press "ALARM 1"
button to confirm.
3) Wake up mode display will begin
flashing, press TUNE/SKIP to
select the below:
a: Wake up to Radio :
"FM Broadcasting"You have to
pre – tune your desired radio
channel in FM radio mode before setting the wake up function.
b: Wake up to Radio: "AM Broadcasting You have to pre – tune your
desired radio channel in AM radio mode before setting the wake
up function.
c: Wake up to iPod playback
d: Wake up to Buzzer
For Radio Broadcasting and IPOD playback, the default volume is 10
and will increase to 16 gradually. But the volume of Buzzer will not
change. If the wake up mode is set to iPod playback with no iPod
connected, it will become Buzzer alarm.
B. Set Alarm 2
Press and hold ALARM 2 button on the top panel for 2 sec. and repeat
the above 1), 2) & 3) steps in Set Alarm 1 to set ALARM 2.
- 10 -