Sanyo PLC-XE50A Owner's Manual page 47

Enter a Logo PIN code
Select a number by pressing the Point
And then press the Point
and move the pointer. The number changes to "✳". If
you fixed an incorrect number, move the pointer to the
number you want to correct by pressing the Point
button, and then select the correct number by pressing
the Point buttons.
ed
Repeat this step to complete entering a four-digit
number.
After entering the four-digit number, move the pointer to
"Set" by pressing the Point
button so that you can change the following Logo PIN
code lock settings.
If you entered an incorrect PIN code, "Logo PIN code"
and the number (✳✳✳✳) turns red. Enter a correct Logo
PIN code all over again.
Change the Logo PIN code
Logo PIN code can be changed to your desired four-digit
number. Select "Logo PIN code change" with the Point
button and press the SELECT button. Set a new Logo
d
PIN code.
Be sure to note the new Logo PIN code and keep it at
hand. If you lost the number, you could no longer change
the Logo PIN code setting. For details on PIN code
setting, refer to relevant instructions of the PIN code lock
function on pages 50-51.
CAUTION:
WHEN YOU HAVE CHANGED THE LOGO PIN CODE,
WRITE DOWN THE NEW PIN CODE IN COLUMN OF
THE LOGO PIN CODE NO. MEMO ON PAGE 69, AND
KEEP IT SECURELY. SHOULD THE LOGO PIN CODE
BE LOST OR FORGOTTEN, THE LOGO PIN CODE
SETTING CAN NO LONGER BE CHANGED.
Ceiling
When this function is set to "On, " the picture is top/bottom
and left/right reversed. This function is used to project the
image from a ceiling-mounted projector.
Rear
When this function is set to "On, " the picture is left/right
reversed. This function is used to project the image to a
rear projection screen.
buttons.
ed
button to fix the number
8
7
button. Press the SELECT
8
Logo PIN code lock Dialog Box
After a correct Logo PIN code is entered, the
following dialog box appears.
Select On/Off by pressing the Point
change the Logo PIN code.
Ceiling
Rear
Setting
buttons or
7 8
47