Table of Contents
Advertisement
Reject call with
to a caller informing why you could not answer the call.
See
"Answer or reject a
Message
text—Write a text to be sent in a text message
when you reject a call.
Automatic
redial—Select On, and your device makes a
maximum of ten attempts to connect the call after an
unsuccessful call attempt. To stop automatic redialling,
press
.
Summary after
device to briefly display the approximate duration of the
last call.
Speed
dialling—Select On, and the numbers assigned to
the speed dialing keys (
and holding the key. See also
p. 26.
Anykey
answer—Select On, and you can answer an
incoming call by briefly pressing any key under the slide
cover.
Line in use
(network service)—This setting is shown only if
the SIM card supports two subscriber numbers, that is,
two phone lines. Select which phone line you want to use
for making calls and sending text messages. Calls on both
lines can be answered irrespective of the selected line.
100
SMS—Select
Yes
to send a text message
call", p. 27.
call—Activate this setting if you want the
-
) can be dialed by pressing
"Speed dial a phone
Copyright © 2006 Nokia. All rights reserved.
If you select
Line 2
network service, you will not be able to make calls. When
line 2 is selected,
Tip! To switch between the phone lines, press and
hold
Line change
(network service)—To prevent line selection,
select
Line change
card. To change this setting, you need the PIN2 code.
Connection
Data connections and access points
Your device supports packet data connections (
GPRS in the GSM network.
Glossary: General packet radio service (GPRS) uses
number",
packet data technology where information is sent in
short packets of data over the mobile network.
To establish a data connection, an access point is required.
You can define different kinds of access points, such as:
• MMS access point to send and receive multimedia
messages
• Access point for the Web application to view WML or
XHTML pages
• Internet access point (IAP) to send and receive e-mail
and have not subscribed to this
is shown in the standby mode.
in the standby mode.
>
Disable
if supported by your SIM
), such as
Advertisement
Table of Contents
