Sharp MD-R3H Operation Manual page 43

(Continued)
ENTER
1
2
3
4
5
The stop time setting display will appear.
The "hours" display will be automatically increased one hour.
6
7
8
When the digital optical input was selected
1
(Timer standby mode)
2
TIMER REC
Timer recording indicator
Timer recording
DELETE/CLEAR REC LEVEL
Before timer recording, the following preparations are required.
TIMER
MIN MAX
Load a recordable MD.
1
Whilst in the stop mode, press the TIMER button, and then
turn the jog dial until "TIMER SET" appears.
2
Within 10 seconds, press the ENTER button, and then select
the timer mode using the jog dial.
3
Press the ENTER button.
The start time setting display will appear.
4
Enter the "hour", using the jog dial. Then, press the ENTER
button.
5
Enter the "minute", using the jog dial. Then, press the ENTER
button.
The stop time setting display will appear.
6
Enter the "hour", using the jog dial. Then, press the ENTER
button.
7
Enter the "minute", using the jog dial. Then, press the ENTER
button.
The start and stop times are now set.
8
Select the source programme using the jog dial.
ANALOG
If you select the analogue input, adjust the recording level.
(Page 22)
9
Press the ENTER button.
Setting timer for recording:
1
Press the TIMER button.
If the display shows the wrong mode, correct it using the jog
dial.
2
Press the ENTER button.
The settings will appear in order, and the unit will enter the
timer recording stand-by mode. (The power will be turned off.)
Preparations for any equipment connected to this unit
Any equipment, such as a stereo, that is connected to this unit
should be set up in advance as follows:
Set it up so that music to be recorded will be played at the
same time as the timer's start time.
E-37
MD-R3H
DIGITAL OPT DIGITAL COAX