Page 2
Thank you for selecting our appliance Thank you for selecting our appliance Thank you for selecting our appliance Thank you for selecting our appliance Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances.
Contents For the User Important safety information ................4 Operation ......................6 Using the hob ....................8 Cleaning and Maintenance ................9 Service and original spare parts ............... 19 European guarantee ..................19 For the Installer Technical data ....................11 Installation .......................
Important safety information This warnings has been given for the safety of you and others. We therefore ask you to carefully read the procedures of installing and using this appliance. Installation • If the appliance is out of order, disconnect it from the electric supply. The work of installation must be carried out by competent and qualified People Safety...
Page 5
• This appliance is not connected to Environmental Information combustion products After installation, please dispose of evacuation device. It must be the packaging with due regard to installed connected accordance with current safety and the environment. installation regulations. Particular • When disposing of an old appliance, attention shall be given to the make it unusable, by cutting off the relevant requirements regarding...
Operation Before using the appliance re- move all packaging, including the advertising labels and any protective film. Hob burner control knobs The symbols on the knobs mean: = no gas supply = maximum gas supply = minimum gas supply For easier lighting, proceed before putting a pan on the pan support.
Page 7
If the burner does not light even after 15 seconds, release the control knob, turn it the "off" position and wait for at least one minute before trying to light the burner again. To switch off burners To put the flame out, turn the knob to the symbol ( ).
Using the hob Practical hints For the correct use of the burners ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used. Rapid Burner diameter 18-26 cm Semi-rapid Burner diameter 12-22 cm Auxiliary Burner diameter 8-16 cm •...
Cleaning and Maintenance Disconnect the appliance from the electrical supply, before carrying out any cleaning or manteinance work. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. This appliance cannot be cleaned with steam or with a steam cleaning machine.
Should the hob top become heavily soiled, the following products are recommended: - For stainless steel hobs use a proprietary stainless steel cleaner. - For other hobs use Hob Brite or Bar Keepers Friend. Do not leave acid or alkaline substances (e.g.
Installation • The following instructions about IMPORTANT - To ensure a correct installation and maintenance must operation, a saving of energy and the be carried out by qualified long life of the appliance, the voltage personnel in compliance with the pressure of the appliance must regulation in force.
Adaptation to different types of gas A. Injectors replacement • Remove the pan supports. • Remove the burner's caps and crowns. • With a socket spanner 7 unscrew and remove the injectors (Fig. 7), and replace them with the ones required for the type of gas in use (see table «Gas burners»).
Electrical connection The brown coloured phase cable (fitted The appliance is designed to be in the terminal block contact marked with connected to 230 V monophase "L") must always be connected to the electricity supply. network phase. The connection must be carried out in compliance with the laws and Replacement of the voltage regulations in force.
Building in Hob Top Rapid Burner Semi-rapid Burner Auxiliary Burner Control knobs This hob can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The hobs dimensions are shown in Fig. 10. The edge of the cut out must have a minimum distance from the rear wall of 55 mm.
Page 17
Fitting the hob to the worktop Dimensions are given in millimeters The hobs can be installed in a kitchen unit with an opening for insertion whose dimensions are shown in Fig. 11. To install the hob, proceed as follows: 1) Remove the pan supports, the burners caps and crowns and turn the hob upside down.
Possibilities for insertion Kitchen unit with door Proper arrangements must be taken in designing the forniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in Fig.
Service and original spar Service and original spar e parts e parts Service and original spar e parts e parts Service and original spar Service and original spar e parts This machine, before leaving the factory, the problem, the appliance model has been tested and studied by many (Mod.
Page 24
35675-2607 01/08 R. A Subject to change without notice...