Switching To Speakerphone Mode; Switching To The Handset; Using Call Waiting; Accepting A Waiting Call (Camp-On) - Siemens HiPath 3000 Operating Instructions Manual

Making and Answering Calls
Step by Step
Speaker
Call waiting?
16

Switching to Speakerphone Mode

Precondition: You are conducting a call with the hand-
set.
I
and Hold down the key and replace the handset.
(in the U.S.: press the key once and replace the hand-
set). Then release the key and continue the call.

Switching to the Handset

Precondition: You are engaged in a call in speaker-
phone mode.
C H
and Lift the handset. Continue the call.

Using Call Waiting

Callers can still reach you while you are engaged in an-
other call. A signal alerts you to the waiting call.
You can either ignore or accept the waiting call.
When you accept the waiting call, you can either end
the first call or place it on hold and resume the call later
on.
You can also bar call waiting or the call waiting tone
Æ page 17.

Accepting a Waiting Call (Camp-On)

Precondition: You are engaged in a phone call and hear
a tone (every six seconds).
Ending the first call and answering the waiting call:
I
Replace the handset. Your telephone rings.
C
Answer the second call. Lift the handset.
Placing the first call on hold and answering the sec-
ond call:
Select and confirm.
This function is not available with
optiPoint 500 economy and optiPoint 500 basic.
This function is not available with
optiPoint 500 economy and optiPoint 500 basic.