Yamaha WOLVERINE YFM35XV Owner's Manual page 44

Hide thumbs Also See for WOLVERINE YFM35XV:
Table of Contents

Advertisement

4. Shift the drive select lever into the neutral po-
sition. The neutral indicator light should come
on. If the indicator light does not come on,
have a Yamaha dealer check the electrical cir-
cuit.
NOTE:
The engine can be started under the following con-
ditions:
G
The drive select lever is in the neutral position.
G
The rear brake lever is applied with the drive se-
lect lever in any position. However, it is recom-
6
mended to shift into the neutral position before
starting the engine.
5. Use the starter (choke) in reference to the fig-
ure:
Position (1):
Cold engine start with ambient temperature
below 5 °C (40 °F).
Position (2):
Cold engine start with ambient temperature
between 0 °C (30 °F) and 30 °C (90 °F).
Position (3):
Cold engine start with ambient temperature
above 25 °C (80 °F).
Ambient temp./starter (choke) position
1. Fully open
2. Half open
3. Closed
4. Starter (choke)
6. Completely close the throttle lever and start
the engine by pushing the start switch.
NOTE:
If the engine fails to start, release the start switch,
then push it again. Pause a few seconds before
the next attempt. Each cranking should be as short
as possible to preserve battery energy. Do not
crank the engine more than 10 seconds on each
attempt.
6-2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wolverine yfm35xw

Table of Contents