Start Switch; Throttle Lever; Cooling Water Pilot Outlets - Yamaha FX High Output WaveRunner 2007 Owner's/Operator's Manual

Features and functions
EJU31190

Start switch

Push the start switch (green button) to start
the engine.
1 Start switch
NOTE:
The engine will not start when the lock mode
of the Yamaha Security System has been se-
lected, the clip is removed from the engine
shut-off switch, or the throttle lever is
squeezed. (See page 38 for Yamaha Security
System and low-RPM mode selection proce-
dures.)
EJU31210

Throttle lever

Squeeze the throttle lever to increase engine
speed.
1 Throttle lever
Release the throttle lever to decrease engine
speed or to return it to the idle position.
33
EJU31240

Cooling water pilot outlets

This watercraft is equipped with cooling water
pilot outlets.
When the engine is running, cooling water is
circulated in the engine, and then it is dis-
charged from the pilot outlets.
To check for proper operation of the cooling
system, check that water is being discharged
from the port (left) pilot outlet. If water is not
being discharged from this outlet, cooling wa-
ter may not be circulating in the engine. When
this occurs, stop the engine and check for the
cause. (See pages 45 and 98 for more infor-
mation.)
NOTE:
If the cooling water passages are dry, it will
G
take about 60 seconds for the water to
reach the outlet after the engine is started.
Water discharge may not be constant at
G
idle, therefore, open the throttle a little to
check that water discharges properly.
Water discharge may not be constant at the
G
starboard (right) pilot outlet, however, if it is
constant at the port (left) pilot outlet, the
cooling system is operating normally.