Multifunction Information Center - Yamaha FX High Output WaveRunner 2007 Owner's/Operator's Manual

Low-RPM mode
If the beeper sounds three times, the low-
RPM mode is activated and the "L-MODE" in-
dicator light comes on.
1 "L-MODE" indicator light
Maximum engine speed (r/min) in the low-
RPM mode is limited to approximately 80% of
the maximum engine speed in the normal
mode.
NOTE:
If neither the start switch nor the remote
G
control transmitter is operated within 25
seconds after the unlock button is pressed
to select the unlock mode, the multifunction
meter display and the "L-MODE" indicator
light will go off. If this occurs, press the lock
button on the transmitter briefly to select the
lock mode, press the unlock button briefly to
select the unlock mode, and then press the
unlock button again for more than 4 sec-
onds to select the normal mode or low-RPM
mode.
While the engine is running, input from the
G
remote control transmitter is not received.
ECJ00080
CAUTION:
If the remote control transmitter does not
operate when its buttons are pressed, the
battery may be low. Have a Yamaha dealer
replace the battery.
Features and functions
EJU34900

Multifunction information center

The multifunction information center is
equipped with the following three main com-
ponents for help and convenience in operat-
ing the watercraft.
1 Analog speedometer/tachometer and indi-
cator lights
2 Left multifunction display and operation but-
tons
3 Right multifunction display and operation
buttons (for FX Cruiser High Output)
ECJ00730
CAUTION:
Do not run the engine for more than 15
seconds when checking the operation of
the meter on land. The engine could over-
heat.
NOTE:
When the multifunction information center
G
starts operating, the analog speedome-
ter/tachometer makes one sweep, all dis-
plays light up for 2 seconds, and then the
meter starts to operate normally.
The multifunction information center will
G
continue to operate for 25 seconds after the
engine stops.
40