Preparation; Mounting The Touch Panel - Sharp PN-ZT10E Operation Manual

Preparation

Mounting the touch panel

Caution
• Consult your dealer about mounting the touch panel. Mounting the unit should not be conducted by the customer
on their own.
• The touch panel is heavy. Mounting must be performed by two or more people.
• Do not mount a touch panel to the monitor other than the applicable model. Otherwise, the unit may fall and cause
malfunction or injury.
• Mount the touch panel to the monitor after mounting the monitor to the stand or other mountings. Do not try
to mount the touch panel by placing the unit on the fl oor and then placing the monitor over it. This may cause
damage or a malfunction.
• Check that the clearance between the monitor and the touch panel is not too great.
1. Attach the mounting brackets (supplied) at the two positions on the rear of the touch panel for
initial fi xing.
Attach the mounting brackets in the orientation shown in the illustration.
During the initial fi xing, secure the brackets so that they are raised at the highest position.
Touch panel (rear side)
2. Place the touch panel over the front side of the monitor.
Be careful that the touch panel does not hit the monitor.
Mounting bracket (supplied)
Mounting screws (supplied)
Touch panel (rear side)
9
E