Sharp PN-ZT10E Operation Manual page 19

Tips
• When the pen tip is worn or damaged, replace the tip.
Pull out the old tip and insert a new one.
Setting the touch pen ID
When more than one pair of touch panels and touch pens are used in proximity, you need to specify ID
numbers to identify individual pairs.
Tips
• Use the touch pen within a range of about 5 m from the front of the touch panel.
1. Open the Basic Setting screen of the TouchPanel Setting Program.
(1) Click "TouchPanel Setting Program" on the taskbar and select "Basic Setting" of the programme.
2. Specify the ID number of the touch pen.
(1) Remove the battery cap of the touch pen.
Leave the batteries inside.
(2) While pressing the tip of the touch pen,
1) Attach the battery cap and wait for two seconds or more.
2) Slowly press the function switch three times.
(3) Release the pen tip and slowly press the function switch three times.
(4) Press the pen tip.
(5) Press the function switch to specify the ID number.
Every time the switch is pressed, the ID number shown at "PenID Display" changes.
(6) When a desired ID number is displayed, press the pen tip.
The selected ID number is set as the number shown at "PenID Display".
3. Specify the ID number of the touch panel.
(1) Select an option from "PenID Setting" in the "Basic Setting" screen.
ID Prohibition: The touch panel can be operated regardless of the ID number of the touch pen.
ID No.1 to 4: The touch panel can be operated only with the touch pen with the same ID
number.
(2) Click "OK".
17
E