Ii. Set Pin; Language; Installation; Automatic Channel Scan - Sharp TU-R252H Operation Manual

6.2.10.ii. SET PIN

To change the PIN code for this unit. Use "5/6" on
the remote control to go to "Set PIN" option. Press
OK to display the "Set PIN" window. Use NUMERIC
buttons to enter new pin code you will need to input
your new pin a second time for verification purposes.
If Both pin codes are four digits long and the same,
the pin will be changed. The factory default pin code
is 0000, if you change the pin code make sure you
write it down and keep it safe.

6.3. LANGUAGE

In this menu the user can adjust the preferred language. Language is changed by pressing OK on the
remote control.
Menu: shows the language of the system
Preferred
These settings will be used if available. Otherwise the current settings will be used.
Ø Audio: by pressing "3/4" on the remote control change the audio language.
Ø Subtitle: alter the subtitle language with"3/4" on the remote control. The chosen language will
be seen in subtitles.
Ø Guide: by pressing "3/4"on the remote control change the guide language.
Current
Ø Audio: if audio language is supported change the audio language by pressing "3/4"on the
remote control.
Ø Subtitle: if subtitle is backed up alter the subtitle language using "3/4"on the remote control. The
chosen language will be seen in subtitles.

6.4. INSTALLATION

6.4.1. AUTOMATIC CHANNEL SCAN

Automatic channel
activated by selecting OK when
the line is highlighted. A pop-up
menu appears on the screen,
select "YES" the automatic scan
begins. All the multiplexes are
searched and a channel table is
created automatically.
channels found are stored in a
sorted form with respect to their channel numbers. Selecting "NO" will cancel the operation.
scan is
All
28