Panasonic AG-MC15P Operating Instruction page 2

Notice for the purchaser/user of the apparatus
1. Applicable standards and operating environment
The apparatus is compliant with:
• standards EN55013 1990, A12/1994, A13/1996, A14/1999
and EN55020 1994, A11/1996, A12/1999, A13/1999, A14/1999
and EN61000-3-2 1995, A1/1998, A2/1998, EN61000-3-3/1995
• description of electromagnetic location
The environments encompassed by this standard are residential, commercial and
light-industrial locations, both indoor and outdoor.
2. Pre-requisite conditions to achieving compliance with the above
standards
<1> Peripheral equipment to be connected to the apparatus and special connecting
cables
• The purchaser/user is urged to use only equipment which has been recommended
by us as peripheral equipment to be connected to the apparatus.
• The purchaser/user is urged to use only connecting cables recommended by us or
their equivalent as the optional special cables.
<2> For the connecting cables, use shielded cables which suit the intended
purpose of the apparatus.
• Video signal connecting cables
Coaxial cables, which are designed for 75-ohm type high-frequency applications,
are recommended for analogue video signals.
• Audio signal connecting cables
Use shielded cables, which provide quality performance for high-frequency
transmission applications, for analogue audio signals.
• Control system connecting cables
Use shielded cables, which provide quality performance for high-frequency
transmission applications, as control system connecting cables.
3. Performance level
The performance level of the apparatus is equivalent to or better than the performance
level required by these standards.
However, the apparatus may be adversely affected by interference if it is being used in an
EMC environment, such as an area where strong electromagnetic fields are generated (by
the presence of signal transmission towers, cellular phones, etc.). In order to minimize the
adverse effects of the interference on the apparatus in cases like this, it is recommended
that the following steps be taken with the apparatus being affected and with its operating
environment:
1. Place the apparatus at a distance from the source of the interference.
2. Change the direction of the apparatus.
3. Change the connection method used for the apparatus.
4. Connect the apparatus to another power outlet where the power is not shared by
any other appliances.
Attention:
In order to avoid EMC-disturbance to this unit during operation, it is necessary to hold a
distance of at least 70 cm, when using a mobile GSM-telephone in calling mode.
– 2 –