Fujitsu AD11 Manual page 47

SDRAM Trc Timing Value
The feature allows user to set the Trc timing value (Bank Cycle time -
minimum time from activate to activation of same bank).
The options are: 3 Cycle, 4 Cycle, ..., 10 Cycle.
SDRAM Trp Timing Value
The feature allows user to set the Trp timing value (Precharge time - time
from precharge command to when back can be activated).
The options are: 3 Cycle, 2 Cycle, 1 Cycle, 4 Cycle.
SDRAM Tras Timing Value
The feature allows user to set the Tras timing value (Minimum Bank active
time - time from activate to precharge of same bank).
The options are: 2 Cycle, 3 Cycle, ..., 9 Cycle.
SDRAM CAS Latency
If the CAS latency of your installed SDRAM DIMM is 2, The selection 2
will enhance system performance. The options are: 2 Cycle, 2.5 Cycle,
SDRAM Trcd Timing Value
The feature allows user to the Trcd timing value ( Ras to Cas latency Delay
from activate to read/write command).
The options are: 1 Cycle, 2 Cycle, 3 Cycle, 4 Cycle.
BIOS Setup
3 - 11