Front Panel Block Connector: Fpnl - Fujitsu AD11 Manual

AD11 Mainboard Manual

Front Panel Block Connector: FPNL

This block connector includes the connectors for linking with IDE LED, sleep
LED, power LED, power button, sleep button, reset button and speaker on the
front panel of the system case. Please identify polarities of plug wires for the
case speaker and LEDs. Please ask vendor about this information when you
buy them and install the system by yourself. The plug wire polarities of these
buttons will not affect the function.
Reset Button is connected to the reset button. Push this switch to reboot the
system instead of turning the power button off and on.
Power Button is connected with power button. Push this switch allows the
system to be turned on and off rather than using the power supply button.
Power LED is connected with the system power indicator to indicate whether
the system is on/off. It will blink when the system enters suspend mode.
Speaker is connected with the case speaker.
IDE LED is connected to the IDE device indicator. This LED will blink when
the hard disk drives are activated.
Sleep LED is connected with sleep mode indicator.
Sleep Button is connected to the sleep button. Push this switch to enter the
power saving mode while system in full-on mode.
2 - 22