Table of Contents
Advertisement
NOTE
CAUTION
4
1. General
This booklet briefl y outlines where and how to install the system controller.
Please read over the entire set of instructions for the indoor and outdoor units
and make sure all accessory parts listed are with the controller before beginning.
Give these instructions to the customer after fi nishing the installation.
Part Name
System Controller
Rubber bushing
(7/8 in.)
Screws for fixture
(1-3/16 in.)
Wire joints
Switch box
T10 cable
CRV cable
Identification label
2. Installation site selection
•
Install the system controller at a height of between 3 and 5 ft. above the fl oor.
•
Do not install the system controller in a place where it will be exposed to
direct sunlight or near a window or other place where it will be exposed to the
outside air.
•
Be sure to install the system controller vertically, such as on a wall.
3. How to install the system controller
•
Do not twist the control wiring together with the power wiring or run it
through the same metal conduit, because this may cause a malfunction.
•
Install the system controller away from sources of electrical noise.
•
Install a noise fi lter or take other appropriate action if electrical noise
affects the power supply circuit of the unit.
Do not supply power to the unit or try to operate it until the tubing and
wiring to the outdoor unit is completed.
Figure
Q'ty
1
4
2
2
1
1
1
1
Advertisement
Table of Contents
