Table of Contents
Advertisement
Installation procedure
(1) Remove the fl at-top screw on the bottom of the back case. When you open up the decorative cover, you will see two
notches under the controller. Inset a coin or other fl at object into these notches and pry off the back case. (Fig.1)
(2) Connect the wires to terminal base of the system controller (see next page).
(3) Attach the back case with the 2 screws (1-3/16 in.) provided.
(4) To fi nish, fi t the back tabs of the back case into the system controller and mount it using the fl at-top screw.
Gap
2 screws (1-3/16 in.)
System
controller
Gap
Switch box
(with cover)
Flat-top Screw
Back case
Fig. 1
5
Advertisement
Table of Contents
