Kenwood Ariete SC 7.30 Instructions For Use Manual page 6

Table of Contents

Advertisement

EN
Always switch off the appliance at the main switch and unplug it from the power mains before refilling it.
Never allow the detergent sprayed from the appliance to come into contact with power sockets and/or other electrical
appliances or wires.
Make sure that hands are dry before using or adjusting the appliance switches, before touching the plug or power con-
nections.
Never leave the appliance exposed to the elements (rain, sunshine, etc.).
Never place the appliance on or near to sources of heat.
Make sure that the power cord does not come into contact with hot surfaces.
Never point steam jets in the direction of people, animals or plants or towards appliances that
contain electrical parts (e.g. oven interiors).
Never direct steam jets onto the appliance itself.
Never immerse the body of the appliance, plug or power cord in water or other liquids; clean them with a damp
cloth.
Never use the appliance if the power cord or plug are damaged or if the appliance is faulty / damaged.
All repairs, including the replacement of the power cord, must only be carried out by an Kenwood Assistance Centre or
by technicians authorised by Kenwood, so as to prevent any risks.
This appliance has been designed for
During use, the appliance contains pressurised steam : improper use can be dangerous. The appliance is designed
for domestic use only, as stated in the manual. The manufacturer cannot accept any liability for damage cause through
improper or incorrect use of the appliance.
When the appliance is not in use, always lock the steam dispensing button with the special cursor.
If the steam button is pressed before the boiler has reached the optimum temperature, then water instead of steam could
come out of the nozzle.
Never touch hot surfaces while using the product. Leave attachments to cool before replacing them.
Even when the appliance is not in operation, unplug it from the power mains and leave it to cool before inserting
or removing single parts or before cleaning it.
IMPORTANT: danger of scalds
Ÿ
NEVER OPEN THE SAFETY CAP DURING USE.
IMPORTANT:
Before unscrewing the safety cap, proceed as follows:
ü unplug the appliance from the mains power socket;
ü slowly unscrew the safety cap and wait a few seconds
IMPORTANT possible damage to materials
Your Kenwood Steam Cleaner is also ideal for ceramic, marble, vinyl, linoleum and sealed hardwood floors.
Warning: DO NOT use on sealed wood floors, or timber floors in high traffic areas where the protective coating may have
worn out. DO NOT leave the mop in one spot during use or while hot for more than 15 seconds, this could cause the
wood grain to rise. When using on surfaces treated with wax, the wax may be removed by the heat and steam action. It
is recommended to try the appliance on a small inconspicuous area before use and refer to care instructions from the
flooring manufacturer.
Not recommended for use on CORK or CORK tiles.
Kenwood will not accept any responsibility for damage caused to flooring if the above warnings have been ignored.
Never use in swimming pools containing water.
DANGER from other causes
domestic use only and may not be used for commercial or industrial purposes.
WARNING danger of scalds
before unscrewing it fully.
- 4 -

Advertisement

Table of Contents
loading

Table of Contents