Table of Contents
Advertisement
3. Web Server Quick Guide
3. Web Server Quick Guide
3.1. Introduction
3
These instructions describe the Protect PV Web Server, which facilitates remote access to the
inverter.
Refer to the download area at www.aegps.com/solarinverters for the newest instructions.
3.2. Supported Characters
In all language versions, the following characters are supported and can be entered via the
Web Server:
Letters
Capital letters
Numbers
Special characters .,-+?!@:;/\_()#* %
Note! No spaces are allowed in inverter name.
For plant, group and inverter name, only the following characters are supported:
Letters
Capital letters
Numbers
Special characters - _.
Note! No spaces are allowed in inverter name.
3.3. Access and Initial Setup
3.3.1. Access via PC Ethernet Interface
Setup Sequence:
1.
2.
3.
4.
5.
12
abcdefghijklmnopqrstuvwxyz
ABCDEFGHIJKLMNOPQRSTUVWXYZ
0123456789
abcdefghijklmnopqrstuvwxyz
ABCDEFGHIJKLMNOPQRSTUVWXYZ
0123456789
Change the Web Server logon and password of the master inverter immediately
for optimal security when connecting to the internet. To change the password go
to [Setup → Web Server → Admin].
Select which inverter will be set up as master.
Open the cover of this inverter. Refer to the Protect PV Installation Manual for instruc-
tions.
Connect the inverter RJ45 interface to the PC Ethernet interface using a patch cable
(network cable cat5e, crossed or straight through).
On the PC, wait until Windows reports limited connectivity (if no DHCP is present).
Then open the internet browser.
Type http://invertername in the address field:
•
Find the serial number on the product label, located on the side of the hous-
ing.
•
'Invertername' is the final 10 digits of the serial number (1).
8000038784_00_BAL_en / L00410565-01_02
Hide quick links:
Advertisement
Table of Contents
