Table of Contents
Advertisement
10
en | Connection
3.3
Ethernet Connection (IP models)
The NEI-30 connects to a 10 Base-T/100 Base-TX network either directly or via a hub. Both
video and control are transmitted over a standard TCP/IP network using the built-in web
server. In addition, power can be supplied to IP camera models via the Ethernet cable
compliant with the Power-over-Ethernet Plus (IEEE 802.3at PoE+) standard.
CAUTION!
Ethernet connections must be made to non-exposed (indoor) networks only.
WARNING!
The IP camera models can accept power from the 12 VDC / 24 VAC power input or from the
Ethernet input. Ensure that the camera receives power from only one source.
Cable Type
Maximum Distance
Bandwidth
PoE+
Terminal Connector
3.4
Alarm Output Connections
Figure 3.1 Terminal Block for Alarm Output Connections
# Label Description
1 D1
2 D2
3 T1
4 T2
5 V1
6 V2
7 NC
F.01U.166.250 | 1.0 | 2011.04
CAT-5E or CAT 6 Ethernet
100 m (328 ft)
10/100 Base-T Fast Ethernet
IEEE 802.3at standard
RJ45
Illuminator on alarm output connection 1 Black
Illuminator on alarm output connection 2
Voltage free and either open (Illuminator
off mode) or closed (Illuminator on mode)
Tamper alarm output connection 1
Tamper alarm output connection 2
Voltage free and either open or closed
(normally closed)
Camera alarm output connection 1
Camera alarm output connection 2
Not connected
Quick Install Guide
NEI-30 | VEI-30 Dinion Infrared Imager
Wire Color Connects To...
Pin 1 of terminal block CN10
on single channel
Orange
Pin 2 of terminal block CN10
on single channel
Brown
Pin 1 of terminal block CN11
on single channel
Gray
Pin 2 of terminal block Cn11
on single channel
White
Pin 6 of terminal block X453
on processor PCBA
Yellow
Pin 3 of terminal block X453
on processor PCBA
(not
connected)
Bosch Security Systems, Inc.
Advertisement
Table of Contents
