Making Pan Adjustments; Making Tilt Adjustments - Bosch NEI-30 Quick Install Manual

NEI-30 | VEI-30 Dinion Infrared Imager
4.3

Making Pan Adjustments

1.
2.
3.
4.4

Making Tilt Adjustments

1.
2.
3.
4.
Bosch Security Systems, Inc.
Using the 4 mm hex key, loosen the bolts at the base of the "u bracket" to make the
necessary pan adjustments.
When loosened, adjust the camera to the desired pan angle.
Tighten the bolt to secure in place.
Unscrew the round caps (CCW) where the bracket attaches to the camera housing to
expose the bolts for tilt adjustment.
Using the 4 mm hex key, loosen the bolts and make the necessary tilt adjustments.
Tighten the bolts to secure the camera in place.
Replace the round caps when you finish the adjustments.
Figure 4.4 Example orientation: Camera rotated 90 degrees left, pointing up 50 degrees
Figure 4.5 Example orientation: Camera rotated 90 degrees right, pointing down 50 degrees
Quick Install Guide
Configuration | en 13
F.01U.166.250 | 1.0 | 2011.04