Example: To set "PM 6:30" (Using the remote control)
1. Press [z/I]. The STANDBY indicator goes off.
2. Press [CLOCK] while holding [SHIFT] down.
"AM 12:00" blinks.
3. Press [ADJUST] while holding [SHIFT] down.
The "hours" display blinks.
4. Press [NEXT/TUNE+] or [PREV/-TUNE] to set the "hours".
5. Press [ADJUST] while holding [SHIFT] down.
The "minutes" display blinks.
6. Press [NEXT/TUNE+] or [PREV/-TUNE] to set the "minutes".
7. Press [ADJUST] while holding [SHIFT] down.
The clock starts.
•
The time can be set accurately by pressing [ADJUST] while
holding [SHIFT] down when a time signal is heard.
To display the clock during operation
Press [CLOCK] while holding [SHIFT] down to display the clock.
(If leave it, the original display returns after approximately 15
seconds.)
Press [CLOCK] again while holding [SHIFT] down to return to the
original display.
Note:
If a power failure occurs, reset the clock again.
ADJUSTING THE CLOCK
-E14-
LAST MEMO
1
DISPLAY
RETURN
TV POWER
TV CH
TV/VIDEO
TV CH
SHIFT
SHIFT
ENTER
REV
SLOW
2
1
2
ANGLE
A.REPLAY
4
5
AUDIO
7
8
TIMER
ADJUST
0
CLOCK
CLOCK
TU/BAND
SHIFT
SHIFT
ENTER
REV
SLOW
3, 5, 7
1
2
ANGLE
A.REPLAY
4
5
AUDIO
7
8
ADJUST
TIMER
ADJUST
0
CLOCK
TU/BAND
REPEAT
SEARCH MODE
PROG
TV VOL
TV VOL
CLEAR
TRIM
FWD
SLOW
3
ZOOM
6
SLEEP
9
SET/CLEAR
+10
SOURCE
CLEAR
TRIM
FWD
SLOW
4, 6
3
ZOOM
6
SLEEP
9
SET/CLEAR
+10
SOURCE