Hitachi 51F710 Operating Manual page 60

Video 2 Auto Link
Use this function to automatically turn the TV on and tune to Video2 when it detects a video signal to
input 2.
Setup
Set The Inputs
Rename List
AVR
Video1
CAM
Video2
CBL
Video3
CBL2
Video4
Reset
Video5
Move Return
SEL
Use the CURSOR buttons ,
When AUTO is selected, the TV will turn on and tune to Video2 automatically, when the Video2 input device is turned on. This is con-
venient when you want to watch a movie with your VCR, laserdisc player, or DVD player.
When REMOTE is selected, the TV will turn on and switch to Video2 automatically when the Video2 input device is turned on and the
VCR, laserdisc, or DVD play button on your remote control is pressed.
This is convenient when you want to record a movie with your VCR and watch it later.
Select Off to disable this function.
Press EXIT to quit menu.
NOTES: 1. Once the TV has been turned on using the AUTO LINK feature, it must be reset before AUTO LINK is used again. To
do this, turn your VCR, laserdisc, or DVD player OFF. This feature is now reset and will turn on your TV as described
above.
2. When using REMOTE mode, any remote control button will substitute for your video input device play button. However,
intended operation is for use with your VCR, laserdisc, or DVD play button.
3. If no remote control button is pressed after the TV is turned on by AUTO LINK, the TV will automatically turn off after
three hours.
DVD PVR STB2
DVD2 PVR2 VCR
DVD3 SAT VCR2
LD STB VCR3
, or , then press the SELECT button to change AUTO LINK setting.
Setup
Set The Inputs
Rename List
Video1 AVR
Video2 CAM
Video3 CBL
Video4 CBL2
Video5 Reset
Auto Link
Auto Remote
Move Return
SEL
60
SETUP
DVD PVR STB2
DVD2 PVR2 VCR
DVD3 SAT VCR2
LD STB VCR3
Off