Hitachi 51F710 Operating Manual page 72

1 - SEPARATION PROCEDURE CONTINUED
STEP 4 Cont.
(c)
STEP 5 Remove the joint connector bolts from each side of the back cover using the allen wrench that is provided inside of the instruction bag, see (a) and
(b).
(a)
Remove from the back side of the TV set only the top 4 screws of the lower rear cover, see (b), as shown by the arrows on the rear cabinet label,
STEP 6
see (a). Do not remove the rear cover board. Remove the (4) four side screws that hold the back cover to the cabinet, see (c) as shown on the label
(a). Total of 8 screws will be removed.
(a)
Caution: When the TV is separated, the top portion weights 45 lbs. This task should be done by two persons when separating this TV.
STEP 7
This assembly contains fragile parts, such as glass and the viewing screen. Avoid any type of impact that could cause breakage of these compo-
nents. Remove top portion by grabbing the bottom corner of frame and the back cover, see (a)(b). Lift upwards, see (c)(d), gently place the top por-
tion on the the floor, see (e).
(a)
57" DISASSEMBLY/ASSEMBLY INSTRUCTIONS
(d)
(b)
(b)
(b)
(d)
(c)
(e)
72
(c)