Advertisement
Names of parts and their functions (Fig. 1)
Heating head (titanium material)
Attach cotton and apply it to your skin.
The device vibrates while being used in
modes other than "Cool."
Mode indicator lamp
Mode
During preparation
Orange lamp
HOT CLEANSING
flashing
HOT MOISTURIZE
HOT MASK
Blue lamp flashing
COOL
Mode switch button
Every time the button is pressed, the
mode for use will be switched.
("HOT CLEANSING" is initially set.)
Power switch ("
Turn on the power switch, and it will turn
"On." Press it again, and it will turn "Off."
An automatic shutoff function is equipped,
so if the device is not used for around 3
minutes, it will automatically turn "Off."
Body socket
Body
Level indicator lamp
LOW (green): MEDIUM (green): HIGH (red)
When the power switch is switched to "On,"
the lamp indicating "Low" is turned on. This
lamp is not turned on in "Cool" mode.
Level switch button
Every time the button is pressed, "the
strength" of the electrical potential will
change. There will be no change in vibration
strength. ("Low" is initially set.)
Preparation before use
Never use the device when you have a wound or an inflammation on
your skin. (Cause of problems with or damage to your skin.)
Remove jewelry or contact lenses.
(Cause of problems with your skin or physical discomfort.)
1. About mode switching
Mode
HOT CLEANSING (cleans fine residue
remaining in pores)
HOT MOISTURIZE (performs
moisturizing care by allowing moisturizing
ingredients to penetrate into skin)
HOT MASK (enhances the effect of
milky lotion or sheet mask)
COOL (tightens the pores of your skin
by cooling effect)
During use
Orange lamp
lights
Blue lamp lights
")
Buzzer (Switching sound/ready
sound/warning sound/finish sound)
Every time the switch or button is
pressed, the switching sound will beep.
When the preparation is completed in
"Cool" mode, the ready sound will beep.
The warning sound will beep to indicate
the continuous use of "Cool" mode.
In the event of a failure, an abnormality
detection sound will beep. When each
mode is finished, the finish sound will
beep.
Cooling head (aluminum material)
Apply this head to your skin in "Cool"
mode.
Back plate (titanium material)
Touch this part and apply the heating
head to your skin in modes other than
"Cool," and the device will start to
operate.
Power adaptor
Model: KH-186B
Power plug
Instrument plug
Cord
Accessories
Rings (two) : Rings for attaching cotton.
Stand
Materials needed
Use new cotton saturated with your regular
toner.
Use new cotton saturated with your regular toner.
If you use a gel-like or thick toner, you can also
apply it to heating head without using cotton.
Use your regular milky lotion or a sheet mask by
applying to skin. Do not use cotton.
Apply the cooling head directly to your skin.
Do not use cotton and toner.
Advertisement
