Fujitsu D2179 Tehnical Manual
  1. Manuals
  2. Brands
  3. Fujitsu Manuals
  4. Motherboard
  5. D2179
  6. Tehnical manual

Fujitsu D2179 Tehnical Manual

System board for econel 100
Hide thumbs
Table of Contents

Advertisement

Quick Links

PRIMERGY
System board D2179
for Econel 100
Technical manual
Däschlein
Fujitsu Siemens Computers GmbH München
81730 Munich
e-mail: email: manuals@fujitsu-siemens.com
Tel.: (0 89) 61 001 - 155
Fax: (++49) 700 / 372 00000
D2179 (Econel 100)
Sprachen: En
Edition November 2005

Advertisement

Table of Contents
loading

Related Manuals for Fujitsu D2179

Summary of Contents for Fujitsu D2179

  • Page 1 PRIMERGY System board D2179 for Econel 100 Technical manual Däschlein Fujitsu Siemens Computers GmbH München 81730 Munich e-mail: email: manuals@fujitsu-siemens.com Tel.: (0 89) 61 001 - 155 Fax: (++49) 700 / 372 00000 D2179 (Econel 100) Sprachen: En Edition November 2005...
  • Page 2 Gesellschaft für Technik-Dokumentation mbH www.cognitas.de Copyright and Trademarks Copyright © 2005 Fujitsu Siemens Computers GmbH. All rights reserved. Delivery subject to availability; right of technical modifications reserved. All hardware and software names used are trademarks of their respective manufacturers.

  • Page 3: Table Of Contents

    Replacing the lithium battery ....Abbreviations ....... D2179 (Econel 100)

  • Page 5: Introduction

    Introduction This technical manual describes the system board D2179, which can be ® equipped with one Intel processor. Further information about drivers is provided in the readme files on the hard disk, on the supplied “ServerSupport“ or “ServerStart“ CDs. You will find further information in the BIOS description.

  • Page 7: Important Notes

    Information on which system expansions are suitable can be obtained from the customer service centre or your sales outlet. The warranty expires if the device is damaged during the installation or replacement of system expansions. D2179 (Econel 100)
  • Page 8 Incorrect replacement of lithium battery may lead to a risk of explosion. The batteries may only be replaced with identical batteries or with a type recommended by the manufacturer. It is essential to observe the instructions on page 25. D2179 (Econel 100)
  • Page 9 Use a grounding cable designed for this purpose to connect yourself to the system unit as you install/deinstall the board. Place all components on a static-safe base. You will find a detailed description for handling ESD components in the relevant European or international standards (EN 61340-5-1, ANSI/ESD S20.20). D2179 (Econel 100)

  • Page 10: Ce Certificate

    Never use sharp objects (screwdrivers) for leverage. CE certificate The shipped version of this board complies with the requirements of the EEC directive 89/336/EEC “Electromagnetic compatibility“. Compliance was tested in a typical PRIMERGY configuration. D2179 (Econel 100)

  • Page 11: Environment Protection

    Environment protection Environment protection Environmentally-friendly product design and development This product has been designed in accordance with the Fujitsu Siemens Computers standard for “environmentally friendly product design and devel- opment”. This means that key factors such as durability, selection and labeling of materials, emissions, packaging, ease of disassembly and recycling have been taken into account.
  • Page 12 EU. To return your used device, please use the return and collection systems available to you. You will find further information on this at www.fujitsu- siemens.com/recycling. For details on take-back and reuse of devices and consumables within Europe, see the manual “Returning used devices“...

  • Page 13: Features

    Chips on the system board ® – Intel E7230 Northbridge ® – Intel ICH7 Southbridge – GBit LAN controller (Broadcom BCM5751) – VGA controller (ATI-VGA) onboard – Super I/O controller (SMSC DME1737) – thermal and system management controller (BMC Heimdall) D2179 (Econel 100)
  • Page 14 – 2 x USB 2.0 ports (front) – VGA port – RJ45 LAN port – parallel port PCI slots – 4 x PCI-X (32 Bit / 33 MHz) slots – PCI-Express x1 slot – PCI-Express x4/x8 slot – PCI-Express x8/x16 slot D2179 (Econel 100)
  • Page 15 – Power on self-test – system boot possible from: – CD/DVD-ROM – USB – LAN – hard disk – floppy disk drive – IPMI V1.5 support Environmental protection Battery in holder Form factor ATX format 12“ x 9,6“ D2179 (Econel 100)

  • Page 16: Main Memory

    Frequenc Description 32Bit y in MHz PCIe x16 PCI-Express x16 slot PCIe x1 PCI-Express x1 slot PCI ex8 PCI-Express x8 slot 32 Bit 33 32 Bit PCI-X bus slot 32 Bit 33 32 Bit PCI-X bus slot D2179 (Econel 100)
  • Page 17 3, 4, 5, 6, 7, 9, 10, 11, 12, 14, 15 The selected ISA interrupt is assigned to the PCI interrupt. You may not select an ISA interrupt that is used by a component on the system board (e.g. controller) or an ISA board. D2179 (Econel 100)
  • Page 18 PCI bus Features Controller oder slot NT LINE Onboard controller Slot PCIe USB 1.1 1st 2nd 3rd 4th 1 (A) 2 (B) 3 (C) 4 (D) 5 (E) 6 (F) 7 (G) 8 (H) D2179 (Econel 100)

  • Page 19: Screen Resolution

    Measurement of the processor temperature, measurement of the inside temper- ature by a temperature sensor on the system board. Fan monitoring Fans that are no longer available, blocked or sticky fans are detected. Fan control The fans are regulated according to temperature. D2179 (Econel 100)
  • Page 20 However, this will only be indicated when the system is switched on again System Event Log (SEL) All monitored events of the system board are recorded in the System Event Log. They could be retrieved after a system reboot via ServerView. D2179 (Econel 100)

  • Page 21: Connectors And Jumpers

    Connectors and jumpers Connectors and jumpers PCI Express x8/x16 PCI Express x1 PCI Express x4/x8 Figure 3: Schematic overview of the system board D2179 1 = Floppy disk drive 7 = Intrusion 2 = Front panel (+ jumper) 8 = Fan (F2)
  • Page 22 Normal operation (default setting). inserted System and BIOS Setup password are skipped when the device is switched on and may be changed. not inserted System and BIOS Setup password must be entered when the device is switched on. D2179 (Econel 100)

  • Page 23: External Connectors

    Features Connectors and jumpers 3.6.1 External connectors Figure 5: External connectors of the system board D2179 1 = PS/2 mouse port 5 = VGA port 2 = Parallel port/printer 6 = Serial port COM1 3 = LAN port 7 = USB1 port...
  • Page 24 Figure 6: LAN connector 1 LAN link/activity green LAN connection no LAN connection flashing LAN transfer 2 LAN transfer rate green + transfer rate 10 Mbit/s (or yellow no connection) green transfer rate 100 Mbit/s yellow transfer rate 1000 Mbit/s D2179 (Econel 100)

  • Page 25: Replacing The Lithium Battery

    Ê Press the locking spring into direction of the arrow (1), so that the lithium- battery jumps out of its socket. Ê Remove the battery (2). Ê Insert a new lithium battery of the same type into the socket (3) and (4). D2179 (Econel 100)

  • Page 27: Abbreviations

    Automatic Server Recovery and Restart Advanced Technology Attachment Battery Backup Unit BIOS Basic Input Output System Baseboard Management Controller CMOS Complementary Metal Oxide Semiconductor COMmunication port Central Processing Unit Double Data Rate DIMM Dual In-line Memory Module D2179 (Econel 100)

  • Page 28: D2179 (Econel

    Electrical Erasable Programmable Read Only Memory EPROM Erasable Programmable Read Only Memory EMRL Embedded RAID Logic EVRD Enterprise VRD Hot-plug Controller In Circuit Emulation Integrated (intelligent) Drive Electronics Integrated Mirror Enhanced IOOP Intelligent Organisation Of PCI IPMB Intelligent Platform Management Bus D2179 (Econel 100)
  • Page 29 Light Emitting Diode Multi Processor Specification Non Maskable Interrupt Original Equipment Manufacturer OHCI Open Host Controller Interface Operating System Peripheral Components Interconnect Prefailure Detection and Analyzing Programmed Input Output Programmable Logic Device PS(U) Power Supply (Unit) Puls Wide Modulation D2179 (Econel 100)
  • Page 30 Small Computer Systems Interface SDDC Single Device Data Correction SDRAM Synchronous Dynamic Random Access Memory SHDG Server Hardware Design Guide System Management Bus Server Management Mode Symmetrically Multi Processing UHCI Unified Host Controller Interface Universal Serial Bus D2179 (Econel 100)
  • Page 31 Abbreviations Video Graphics Adapter Voltage Regulator Down Voltage Regulator Module Wired for Management Wake up On LAN D2179 (Econel 100)
  • Page 33 Comments Fujitsu Siemens Computers GmbH User Documentation Suggestions 81730 Munich Germany Corrections Fax: (++49) 700 / 372 00000 email: manuals@fujitsu-siemens.com http://manuals.fujitsu-siemens.com Submitted by Comments on System board D2179 for Econel 100 Technical manual D2179 (Econel 100)
  • Page 35 Comments Fujitsu Siemens Computers GmbH User Documentation Suggestions 81730 Munich Germany Corrections Fax: (++49) 700 / 372 00000 email: manuals@fujitsu-siemens.com http://manuals.fujitsu-siemens.com Submitted by Comments on System board D2179 for Econel 100 Technical manual D2179 (Econel 100)
  • Page 37 Information on this document On April 1, 2009, Fujitsu became the sole owner of Fujitsu Siemens Compu- ters. This new subsidiary of Fujitsu has been renamed Fujitsu Technology So- lutions. This document from the document archive refers to a product version which was released a considerable time ago or which is no longer marketed.

Table of Contents