Dell PowerEdge C410x Hardware Owner's Manual page 8

iii.
4. For multiple host servers connected to a C410x:
a. Initial Power Up Sequence:
i.
ii.
iii. Wait for the Blue UID LED on the left ear tab to stop blinking and then turn
iv.
b. Power Up Sequence:
i.
vi. Wait for the Green power LEDs on the cage(s) to light.
vii. Power up the host server.
viii. Repeat for each host server connected to the C410x.
d. Power Down Sequence:
i. Power down the host server.
ii. Wait for the host server to power off.
iii. Power down the PCI cage(s) associated with the iPass port connected to the C410x.
iv. Wait for the Green power LEDs on the cage(s) to turn off.
v. Repeat for each host serve connected to the C410x.
It is recommended that the following power sequence be followed when using the C410x and BMC 1.32 with a
host server that is Intel E5-2600 Series based:
3. For a single host server connected to a C410x:
a. Power Up Sequence:
i.
ii.
iii. Wait for the Blue UID LED on the left ear tab to stop blinking and then turn
iv.
Power Down Sequence:
b.
i. Power down the C410x.
ii. Wait for the Green power LEDs on the individual PCI cages to turn off and the fans to
iii.
Introduction | 8
Power down the C410x.
Power up the C410x.
Wait for the Green power LEDs on the individual PCI cages to light.
off. When the UID LED turns off the PCIe bus initialization is complete.
NOTE: After the C410x power up the PCIe bus initialization will start. The PCIe bus
initialization status can be checked using IPMITool commands identified in the
"Using the C410x Base Board Management Controller".
Power up the host server.
Power up the PCI cage(s) associated with the iPass port connected to the C410x.
NOTE: The PCI cage power can be applied by pressing the cage power button or
using IPMITool commands identified in the "Using the C410x Base Board
Management Controller" document.
NOTE: The PCI cage power can be removed by pressing the cage power button
or using IPMITool commands identified in the "Using the C410x Base Board
Management Controller" document.
Power up the C410x.
Wait for the Green power LEDs on the individual PCI cages to light.
off. When the UID LED turns off the PCIe bus initialization is complete.
NOTE: After the C410x
power up the PCIe bus initialization will start. The PCIe bus initialization status
can be checked using IPMITool commands identified in the "Using the C410x Base
Board Management Controller".
Power up the host server.
turn off.
NOTE: The host server may report errors of missing devices on the PCIe bus.
Power down the host server.