D-Link AirPro DWL-6000AP User Manual page 20

Tools > Firmware
Upgrade the firmware for the
Access Point. Click on the
link to find upgrades to the
firmware on the D-Link
website at
http://support.dlink.com.
After you have downloaded a
firmware upgrade to your
local drive, click Browse.
Select the firmware and click
Apply to complete the
upgrade.
IMPORTANT! The Access Point must be manually reset after every firmware upgrade. After the
DWL-6000 has been upgraded and reboots, hold down the reset button on the rear panel for a few
seconds. The device will reset and reboot. Upon rebooting after this manual reset, the Access Point
is ready to use. See the Troubleshooting section for complete instructions for manually resetting the
Access Point
Tools > Misc
The Miscellaneous menu is
used to set up Telnet for the
Access Point. By default
Telnet is enabled. You may
disable it by "unchecking"
the Status Enabled option
box. Telnet timeout options
are Never, 1, 5, 10 or 15
minutes.
AirPro DWL-6000AP
18