Technical Data - AEG PROTECT C. 10000 Operating Instructions Manual

2.3

Technical Data

Type power
PROTECT C. 6000 (S)
PROTECT C. 10000 (S)
UPS Input (single phase)
Rated connection voltage
Voltage tolerance range
without battery operation
Nominal frequency
Frequency tolerance range
Curr. consumption (full load)
PROTECT C. 6000 (S)
PROTECT C. 10000 (S)
Input power factor
UPS Output (single phase)
Rated output voltage
Nominal frequency
Voltage waveform
Current Crest Ratio
Overload behaviour
with existing mains
6000 VA (cos ϕ = 0.7 lag.)
4200 W
10000 VA (cos ϕ = 0.7 lag.)
7000 W
1ph ~ / N / PE
220 / 230 / 240 Vac
176 Vac – 276 Vac ± 3 %
50 Hz / 60 Hz
(automatic detection)
± 4 Hz
31 A
50 A
λ
≥ 0.98
220 / 230 / 240 Vac ±1 %
(configuration via software
"CompuWatch")
50 Hz / 60 Hz ± 0.1 %
(depending on mains)
Harmonic distortion
≤ 2% THD (linear load)
≤ 6% THD (non-linear load)
3:1
until 105 % continuous;
> 105 % - < 130 % for 10 min.;
130 % for 1 s
Gapless automatic switch to SBS.
Cutoff after 1 minute at persisting
overload (backswitch at damping
overload = load < 90%).
12