Connecting The Ir Blaster; Checking The Ir Blaster - Motorola DCT6400 Series Installation Manual

3-10 Installation

Connecting the IR Blaster

To connect the IR Blaster:
1 Fit the transmitter into the mounting bracket (refer to Figure 3-5).
2 Plug the mini-pin connector into the
illustrated in Figure 3-6:
Figure 3-6
IR Blaster installed
CABLE
IN
3 Remove the adhesive tape cover from the mounting bracket.
Position and press firmly to attach the mounting bracket to the IR receiver on the VCR. Be
4
careful to route the wire so that it does not prevent loading tapes.

Checking the IR Blaster

The IR Blaster is now located near the receiver and the VCR can be controlled through the
set-top. As a final check, operate the VCR using the remote control from various positions in the
room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.
DCT6400 Series Installation Manual
jack on the rear panel of the set-top rear panel as
IR
ETHERNET SPDIF
R AUDIO IN L
DVI-D OUT
IR
AUDIO OUT
Y
TV
USB
Pass Card
Refer to text to locate
IR receiver on VCR
VIDEO
IN OUT
IEEE 1394
S-VIDEO
Pr
Pb
OPTICAL
SPDIF
DCT6400
VCR