Identifying The Remote Control Buttons - HP PL4245N User Manual

Identifying the remote control buttons

Remote Control
Item
Indicator light
Setup
PWR
TV, CBL/SAT,
DVD/VCR, or
HP.PC
Keypad
Mute
VOL
CH. RTN
HP.MC
CH
Guide/P. Mode
EXIT/Back
8
Introduction
Description
The red light blinks once each time a button is
pushed. If the red light blinks two times when a
button is pushed, the remote control batteries are
low and need replacement.
Use the SETUP button when programming the
remote control for component control; see
"Programming the remote control for component
control" on page 33.
Press PWR once to turn on or off the selected home
entertainment component.
Press one of these buttons once to select a home
entertainment component to control, and then point
the remote control at the component.
HP.PC selects the HP Media Center PC (connected
to the VGA or DVI connector) and enables the HP
MCPC special buttons on the remote. Refer to
"Using the HP MCPC with the TV remote control" on
page 18 for more information.
To program the remote control to operate a cable or
satellite set-top-box or a DVD or VCR; see
"Programming the remote control for component
control" on page 33.
Use the keypad (0 ~ 9, +100) to directly select
channels.
Press MUTE once to turn sound off or on.
Use VOL+ (or VOL–) to raise (or lower) the sound
volume.
Press CH. RTN (channel return) once to recall the
last channel or to page back one screen in the main
menu.
Press HP.MC to start Media Center when using the
HP Media Center PC.
Use CH+ (or CH–) to select the next higher (or
lower) channel.
Selects TV as the input source.
Use GUIDE to display the program guide for a TV
set-top-box or for HP MCPC. Use Picture mode to
scroll through the three picture modes Standard,
Movie, or Dynamic.
Use EXIT to exit out of the selected component's
menu or guide.
Use Back for the HP MCPC.