Table of Contents
Advertisement
Troubleshooting the remote control programming
Problem
Red light does not blink when you press a key.
Red light blinks when you press a key, but
home entertainment component does not
respond.
Remote control does not control home
entertainment components or commands are
not working properly.
No volume on a 2nd TV.
CH+, CH–, and CH.RTN do not work for your
RCA TV.
Changing channels does not work properly.
Tried "Search Method" and still could not find
a working code.
Manufacturer's codes
Manufacturer
Admiral
Adventura
Aiko
Aiwa
Akai
American High
Asha
Audiovox
Beaumark
Bell & Howell
Broksonic
CCE
Calix
Canon
Carver
Cineral
Citizen
Colt
36
Using the TV
Codes for VCR
0048
0000
0278
0037, 0000
0041
0035
0240
0037
0240
0104
0184, 0121, 0209, 0002
0072, 0278
0037
0035
0081
0278
0037, 0278
0072
Solution
Replace the batteries with two (2) new AA non-
rechargeable batteries.
Make sure the remote control is aimed at your home
entertainment component and is not farther than
15 feet away.
Try all listed codes for the component brands being set up.
Make sure they can be operated with an infrared remote
control.
Follow instructions in "Changing Volume Lock."
Due to RCA design (1983-1987), only the original remote
control will operate these functions.
If original remote control required pressing ENTER to
change channels, press ENTER on the Remote control after
entering the channel number.
Try the "Search Method" again after clearing out the
component button as follows: Press and hold SETUP until
red light blinks twice, then release. Next enter 9 - 9 - 2.
Then press and release the component button to be cleared
twice.
Advertisement
Table of Contents
