Troubleshooting During Startup - HP Console Management Controller User Manual

5-2 Compaq Console Management Controller User Guide

Troubleshooting During Startup

If problems occur when starting the Compaq CMC, select the appropriate
symptom for possible causes and actions.
Troubleshooting Guide (CMC Startup)
Description of Fault Symptom
The CMC fails to function after
power up.
Connected sensors are not
recognized by the CMC.
Alarm signals are only indicated on
the CMC but not at the console
management.
There is no shock alarm, despite
the presence of vibrations.
Intrusion alarms do not activate
when door is opened.
Faults are not reported although
sensors are connected.
The interface LEDs are not giving
any signals.
Table 5-1
Solution
Check the AC power connection.
Make sure unit is On.
Make sure sensor is connected to correct port on
the rear of the CMC.
Check the cables to the sensors for cable breaks.
If applicable, check the power supply to the
sensors.
Verify network connection is correctly installed.
Verify the correct IP address is programmed into
the unit.
Contact network administrator.
Use software to adjust sensitivity. See Chapter 4.
Verify intrusion magnetic switches are properly
installed.
Verify sensors connected to the correct port on the
rear of the unit.
Check the sensors for correct installation.
Verify that sensors are connected to the proper
port on the rear of the unit.
Check the connection to the network.
Contact network administrator.