Hardware Installation - D-Link DHP-W311AV User Manual

Section 2 - Installation
Power
Plug the DHP-308AV into a wall outlet near your router. Plug the DHP-W310AV into a wall outlet where you want to extend your network. The Power
LED on both devices will light up to indicate they are receiving power. This may take up to 60 seconds.
Connect the Devices
Press the Common Connect button on the DHP-308AV for three seconds. Then, within two minutes, press the Common Connect button on the
DHP-W310AV for three seconds. The devices will reboot.
Note: When network connectivity is established, the PowerLine LEDs on both PowerLine devices will be steadily lit. This indicates that your PowerLine
network is now secure.
Plug in the Ethernet Cable
You should already own a router connected to a modem. Connect one of the supplied Ethernet cables between your router and the DHP-308AV.
Connect the other Ethernet cable between your DHP-W310AV and your computer. Read the guidelines on the following pages, and continue with
"DHP-W310AV Configuration" on page
Adding More Devices (optional)
If you have more PowerLine devices, or if you add more devices to your network in the future, use the method described above. Be sure to press
the Common Connect button on the new device, and then the Common Connect button on the existing network within the required time frame.
D-Link DHP-W311AV User Manual

Hardware Installation

16.
ROOM A
Internet Router DHP-308AV
ROOM B
iPad
Notebook
DHP-W310AV
12