Epson EU-42 Setup Manual page 47

5. Slide the power supply mode switch up, which is the off
position. The power to Network Image Express is turned
on automatically when the scanner power is turned on.
6. Pass one end of the SCSI cable included with Network Image
Express through the opening on the left side of the control
panel, then connect it to the SCSI connector on Network
Image Express. Make sure the locks on both sides of the
connector snap into place.
7. Connect the other end of the cable to an available SCSI
interface connector on the scanner. Usually, the scanner has
two SCSI interface connectors, either of which can be used.
See the scanner's manual for more information.
Installing EPSON Network Image Express
41