Table of Contents
Advertisement
For assistance with your tool, visit our website at www.porter-cable.com for a
list of service centers or call the Porter-Cable help line at 1-800-487-8665.
KEEP TOOL CLEAN
Keep the mortiser attachment free of dust and dirt, especially the vertical
tubes on which the main frame slides.
with dry compressed air. All plastic parts should be cleaned with a soft damp
cloth. NEVER use solvents to clean plastic parts. They could possibly dissolve or
otherwise damage the material.
Wear ANSI Z87.1 safety glasses while using compressed air.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug are
making good contact in the outlet. Also, check for blown fuses or open circuit
breakers in the line.
MORTISER LUBRICATION
A few drops of oil applied with an oil rag is advisable once every day or two
on the vertical tubes.
NOTE: DO NOT OIL THE SPLINED CUTTER SHAFT
It is advisable to apply a few drops of bearing oil to each end of the crank
every day or two.
BRUSH INSPECTION
For your continued safety and electrical protection, brush inspection and
replacement on this tool should ONLY be performed by an AUTHORIZED
PORTER-CABLE SERVICE STATION or a PORTER-CABLE
SERVICE CENTER.
At approximately 100 hours of use, take or send your tool to your nearest
authorized Porter-Cable Service Station to be thoroughly cleaned and inspected.
Have worn parts replaced and lubricated with fresh lubricant. Have new brushes
installed, and test the tool for performance.
Any loss of power before the above maintenance check may indicate the need
for immediate servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL
UNDER THIS CONDITION. If proper operating voltage is present, return your
tool to the service station for immediate service.
TROUBLESHOOTING
MAINTENANCE
(If applicable)
15
Periodically blow out all air passages
•
DELTA FACTORY
Advertisement
Table of Contents
