NEC DT750 User Manual page 21

Univerge sv8100 terminal
Hide thumbs Also See for DT750:
Table of Contents

Advertisement

1.
Softkey Features
When the softkey corresponding to a desired
feature name is operated, the selected feature
name starts to blink on the LCD. The blinking
display of available features takes precedence
over the display of features specified by the
softkey pattern.
The softkeys can be programmed in System Data to
blink, remain steady, have no indication, or display
a character when either in use or idle.
The following shows the default display patterns of
main features.
FDB (Call Forwarding – Busy Line)
Permits a call to a busy station to be immediately
forwarded to a predesignated station.
FDA (Call Forwarding – All Calls)
Permits all calls designated for a particular station
to be routed to another station regardless of the
busy or idle status of the called station.
FDL (Logged Out IP Station – Call Destination)
Enables a system to transfer the call to
appropriate station when Dterm whose LOGGED
OUT IP STATION – CALL DESTINATION has
already been registered is in logout status.
E-OVR (Executive Override)
Enables selected station users, upon
encountering a busy condition at an internal
station, to bridge into the busy connection.
CW (Call Waiting)
Enables a busy station to receive a second
incoming call. A camp-on indication tone is sent to
the busy station, and the user can use a
switchhook flash to answer the second call.
CB (Call Back)
Provides the ability for a calling station to set a
CALL BACK. The calling station will be rung as
soon as the busy station becomes available.
S&R (Save and Repeat)
Allows a station to save a specific dialed number
and then redial that number later.
MWSET (Message Waiting – Set)
Allows a station to set a Message Waiting
indication or lamp.
HOLD (Call Hold)
Permits a station user to hold a call in progress
and to return to the previously held call.
MWOFF (Message Waiting – Cancel)
Allows a station to cancel a Message Waiting
indication or lamp.
PICK (Call Pickup – Group)
Permits a station user to answer any calls directed
to other lines in the user's preset Call Pickup
Group.
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Univerge sv8100 terminal dt750

Table of Contents