Table of Contents
Advertisement
March 2004
Entering Pipe
Parameters
Entering the Pipe
Material
2-8
In the Pipe submenu, you can specify preprogrammed or special pipe
parameters. While following the programming instructions, refer to
Figure A-1 on page A-1 of Appendix A, Menu Maps. Remember to
record all programmed data in Appendix C, Data Records.
Note: If you are in the PROG menu, proceed directly to Step 4. If
you scroll to a different option, press [ENT] twice to select
that option (once to enter and again to confirm the selection).
To access the Pipe submenu:
1. Press [ESC]. The UTX878 enters the User Program.
2. Press the [ ] key until PROG is bracketed and press [ENT].
3. Use the [ ] and [ ] keys to scroll to the desired Channel and
press [ENT].
4. Scroll to the Pipe submenu and press [ENT].
1. The menu offers two options, Material and Lining. Be sure the
Material option is highlighted, and press [ENT].
2. Two other options now appear, Preprogrammed and Other. Scroll
to the desired option, and press [ENT].
3. The menu now varies with your choice in Step 2.
•
For preprogrammed materials, a list of materials opens. Table 2-1
on the next page covers the available preprogrammed materials on
the list. Press the [
] or [
material. Press [ENT] to confirm the choice.
•
For other materials, the meter asks for the material Soundspeed.
Press [ENT] to open the window. Then use the arrow keys to enter
the known soundspeed, and press [ENT].
] keys to scroll to the appropriate
Programming Site Data
Advertisement
Table of Contents
