Table of Contents
Advertisement
NOTE
NOTE
NOTE
10. Under Target Nodes, Select Nodes in list requiring update,
then click [Get Map Selection]; the node name will appear in the
window.
11. Under components, select [Agent Software], then click [OK].
The installation will begin. A new shell will open and start the
installation script. When prompted for the "as user" password, give
the password of the NT system administrator. When prompted for the
HP_ITO password you can either specify a password, or simply press
and ITO will create a password for you.
Enter
If you are installing the ITO agent software on a domain controller, do
not let ITO create a password for you, but specify your own. You will
need this password again when installing on another domain controller.
The installation script will then install the agent package on the NT
node.
The agent can also be installed via anonymous ftp if you have read/write
access to the ftp home directory drive. Use user ftp and password ftp
The next five steps must be performed on the NT machine. If the NT
system is not physically near you, you can ask someone near the machine
to perform these steps.
12. At the NT machine, log in as the administrator and open a MS-DOS
command prompt.
13. Switch to the ftp home directory and drive
14. Change directory to temp.
15. Type opc_inst. This invokes a script that takes about two minutes
to execute. The script will set up the domain controller as the
Windows NT managed node that can also function as the installation
server for all other NT nodes.
16. The installation is complete when you see the line Installation
program successfully finished. If the installation fails, check
the contents of the installation log file, located in C:\temp\
inst.log. Examine the log file for lines that begin with E-> to find
the cause of the terminated installation.
Chapter 2
Installing ITO Agents on the Managed Nodes
General Installation Tips for Managed Nodes
105
Advertisement
Table of Contents
Troubleshooting
