Removal and replacement procedures
Network cable
✎
The network cable is included in the Cable Kit, spare part number 577214-001.
Before removing the network cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Hard drive (see
b. Memory/wireless module compartment cover (see
c. Optical drive (see
d. Keyboard and switch cover (see
e. Palm rest (see
f. Display assembly (see
g. Top cover (see
h. System board (see
Remove the network cable:
1. Release the RJ-45 connector 1 from the clip built into the base enclosure.
2. Remove the network cable 2.
Reverse this procedure to install the network cable.
4–50
"Battery" on page
"Hard drive" on page
4-9)
"Optical drive" on page
"Keyboard and switch cover" on page
"Palm rest" on page
4-25)
"Display assembly" on page
"Top cover" on page
4-36)
"System board" on page
4-7).
"WLAN module" on page
4-18)
4-27)
4-47)
4-12)
4-20)
Maintenance and Service Guide