Taking Out Discs
Follow the steps below to take out the published/read discs from the stackers.
Caution:
c
If you select stacker 4 as the output stacker in Standard mode or External Output mode,
❏ Do not yank stacker 4 when pulling it out to remove published discs.
❏ Do not pull out stacker 4 when the stacker 4 LED is flashing fast. Discs may be damaged.
1. Open the disc cover (only for output to stacker 2 or 3), and take out the stacker.
2. Take out the published/read discs from the stacker. The output stacker differs
according to the publish mode. Refer to the following table.
Output stacker
Stacker 2
Stacker 3
Stacker 4
Stacker 2
Note:
❏ Be sure to let printed discs dry completely before using them or touching the printed surface.
Allow Epson specified discs to dry for at least 1 hour and other types of discs for at least 24
hours.
Publish mode
Standard mode
Batch mode
Read Back mode
Standard mode
External Output mode
Batch mode
Standard mode
External Output mode
Stacker 3
Number of discs
Up to about 50 discs
Up to about 50 discs
Up to about 5 discs
Stacker 4
Publishing Discs
83