Disassembly For Repair - Kenwood TKR-850 Service Manual

MODIFICATION / DISASSEMBLY FOR REPAIR
6. Desktop Repeater
When you use the repeater on the desktop, attach the 4
spacers to the base of the repeater as shown in figure. With
these spacers attached, the front panel will not touch the
desk surface.
Pegs
Firmly press these pegs
(J59-0302-05) through the
spacers to afix them to
the repeater.
Fig. 7
7. Installing Name Plates
Punch out the name plate card. Then insert the plates
onto the reltative function keys.
You can reconfigure the name plates at any time.
Punch out the
name plate cards
Squeeze and
insert the plates.
Name plates for
the function keys
Name plates
Side view of the key
Fig. 8
Peel off the backing paper
to attach these spacers
(J02-0492-04).
Spacers
(J02-0475-05)

DISASSEMBLY FOR REPAIR

1. How to Remove the Panel Assy (ABS)
Note : You can remove the panel assembly (ABS) without
removing the top panel (A62-0840-03).
1. To remove panel (TX-RX,
2. To remove panel assembly (Front,
( ).
3
3. The panel assembly (ABS) is security fastened by 4 tabs
( 5 ) on top and bottom. You can remove the panel as-
sembly by pulling to front while you are pulling up the
tabs.
TKR-850
2 ), loose 6 screws ( ).
1
4 ), loose 6 screws
17