Changing The Pin (System Pin); Setting The Dialling Mode; Additional Handsets And Base Units - Silvercrest COCOON M1450 TWIN User Manual

Additional handsets and base units

private exchange. The Recall key R 4 causes a brief interruption on the line. You can set
this interruption to 100 ms or 300 ms
1. Press
2. Press 3 or
3. Press
• Press 3 or
4. Press
5. Press or
3
– 'Long' = 300 ms
– 'Short' = 100 ms
6. Press 'Save' 2 to confirm or press
7.3

Changing the PIN (system PIN)

Some functions are only available if you know the PIN for the base unit.
The PIN has four digits. The default setting for the PIN is '0000'. The procedure for changing
the default PIN or to enter a new PIN is as follows:
1. Press
2. Press 3 or
3. Press
• Press or
3
4. Press
5. Press
Once you have entered the correct PIN, you are prompted to enter a new PIN. Enter the
new System PIN and press
6. Enter the new PIN again and press
7.4

Setting the dialling mode

There are two different dialling modes that may be used in telephones.
• Multifrequency dialling (DTMF) or tone dialling (current, modern dialling method)
• Pulse dialling (for older equipment).
Modern equipment is equipped with both functions, these can be changed depending on the
application. Tone dialling is needed for programming or operating functions, for instance, if
you are using the telephone on a private exchange. Where pulse dialling is used,
malfunctions can occur even in normal operation on private exchanges as the system
interprets the pulse dialling signals incorrectly.
Changing the dialling method:
1. Press
2. Press 3 or
3. Press
4. Press 3 or
5. Press
6. Select the dial mode required using
8 Additional handsets and base units
Up to 5 handsets can be registered to one base unit. Each handset can, for its part, be
registered to up to four base units and the user can choose which base unit he wishes to use.
In the default setting as supplied, each handset is registered as Handset 1 to Base unit 1.
28
2 .
11 repeatedly, select 'Base Settings'.
to confirm.
2
11 repeatedly, select 'Recall'.
to confirm.
2
repeatedly to select the desired flash time:
11
2 .
11 repeatedly, select 'Base Settings'.
to confirm.
2
repeatedly select 'System PIN'.
11
and enter the old PIN.
2
. 'Incorrect PIN' will appear in the display if the wrong PIN is entered.
2
2
.
repeatedly, select 'Base Settings'.
11
to confirm.
2
11 repeatedly, select 'Dial Mode'.
to confirm.
2
14 to quit the menu.
.
2
to confirm.
2
3 or 11 and press 'Save' 2 to confirm.
Cocoon M1450 TWIN