Printable Area - Epson PP-100AP User Manual

Printable Area

The printable area is the area available for label printing.
The printable area can be set from the Set Inner/Outer Diameter screen of EPSON Total
Disc Maker.
In the Set Inner/Outer Diameter screen, you can select Standard, Wide, or set manually.
The following diagram shows the printable area for Standard and Wide. Printing will be
done in the gray area.
CD/DVD:
12-cm (4.72") CD/DVD/BD (Standard)
Inner diameter
45 mm (1.77")
Caution:
c
❏ Make sure to set the inner diameter and the outer diameter within the areas shown above.
Printing on sections outside the printable area may damage your CD/DVD/BD drive.
❏ The EPSON Total Disc Maker can set between an inner diameter of 18 mm and an outer
diameter of 119.4 mm (0.71 to 4.70"). However, printing outside printable area (45 to 116
mm) may result in sticking, staining of the disc tray, peeling of print, and blurring of print.
It is recommended to check the disc type before using.
❏ When printing outside the printable area (ink absorbing layer) of the disc occurs, the ink
printed outside the printable area does not fix. Check the label of the printable area of the
disc being used before setting.
❏ Precautions for setting the printable area
-Make sure the printable area set does not exceed the printable area of the actual disc
being used.
-Check whether coloration of print made on the rib (stack ring) is not uniform.
-Printing on the rib (stack ring) may cause ink sticking, disc sticking, and ink erasure after
printing.
45 mm
116 mm
Outer diameter
116 mm (4.57")
12-cm (4.72") CD/DVD/BD (Wide)
25.5 mm
116 mm
Inner diameter Outer diameter
25.5 mm (1.00") 116 mm (4.57")
Product Information
108